VINTAGE Bevel back socket slick 2”W 9"L CHISEL oal 12 3/4 FROM THE CUTTING EDGE TO THE END OF THE SOCKET IS 12 3/4" AND THE CUTTING EDGE IS 2" WIDE AND ABOUT 9" LONG. AS SHOWN THE HANDLE HAS A SMALL

 

Up for grabs a egg beater Millers falls co hand crank drill Greenfield mass made in USA #70 with rose wood handle screw top compartment plus 8 Drill bits works excellent a little tight overall conditi

 

Vintage brass barrel key. On the face is stamped WABASH. On the back side is stamped the number 754, also the capital letter "S" and the word SLAYMAKER. The key appears very old and shows signs of poc

 

fcc4568 Store 4 X WORKABLE PADLOCKS WITH KEYS LOT BUY OF TOOL COLLECTIBLES LOCKS SIZE OF LARGE LOCK 2.3/4 X 1.3/4 INCH OR 7 X 4.5 CM WHERE PRACTICAL,WE ALWAYS COMBINE SHIPPING/POSTAGE TO HELP YOU REDU

 

The Eagle Lock Company of Terryville, CT produced a line of "pancake" padlocks in the last 19th and early 20th centuries. The Belmont is unusual because it is one of the smaller pancakes (just 2" acro

 

UP FOR YOUR CONSIDERATION IS (1) FAMOUS NO NAME IRON PLUMB BOB 3" L CARPENTRY MASONARY NICE CLEAN. PURCHASED AT AN ESTATE SALE I CANNOT FIND A MAKERS MARK ON THE PLUMB NO RUST OR TARNISH NO ENGRAVING

 

This is a rare vintage jaw wrench both sides. 1"/ 1" 3/8  Happy Bidding!!!!!!!!!!!!

 

This is a small woodworking plane the measures 3 1/2 inches long. Unlike some others planes of this size this one has some heft to it. Good for fine work. I've used the same plane while working on bot

 

MATCO 18 INCH LONG FLEXIBLE HEAD RATCHET...WONDERFUL CONDITION. $179.00 New1/2 INCH DRIVE !!!!!!!!!!!!!! HAPPY BIDDING !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

 

Antique seal padlock with working key. Brass and steel. About 2-3/4" inches tall and 2" wide The lock does not " pop " open. Just turn the key ninety degrees then pull on the bail. Seven flat keys, ma