Antique woodworking line scribe wood tool with brass clamp bolt measures 7" long by 1 1/8" wide with a 5/8" rabbet back out.

 

THIS LOT OF 14 ANTIQUE BRACE DRILL BITS ARE ALL IN NICE CLEAN CONDITION ! ! ! THE TWO LARGEST ONES ARE MARKED J. BOOTH A-1. THE COUNTER SINKS ARE MARKED WITH NO. 1, 3, OR 4. PAYPAL PAYMENTS ARE ACCEPT

 

This set of sockets and wrenches is at least 60 years old, maybe older. There are 7 Snap-On sockets with a ratchet and extension, both Snap-On too. There is also a set of 8 Blue Point wrenches. Finall

 

VintageStamped:TESTEDToo Many ScratchesCan't Read The Makers MarkRock HammerWeighs About:1 lb 10 ozMeasures About:14 & 7/8" Long6" WideI Am Not A Hammer ExpertCheck Pictures& Judge For Yoursel

 

Vintage corner chisel. I cannot read the complete makers mark, it appears to MIX & C but I cannot read the initials in front of the MIX. You are buying as is. It needs cleaned and sharpened.

 

budgie2cheap Store A fine old Drawplane in very good condition for its age,good original woodwrm free,solid ash handles with through tanged cores and brass stoppers,the steel has a lovely tone to it a

 

This Auction is for A 9" Antique Draw Knife The only markings I saw on it were in the middle of the blade "Oak Leaf" "Made in U.S.A." Blade is 9" long and total length is 14 1/2" long. There's a coupl

 

IMANNIEMAE Store Antique BRASS Wilson Bohannan PADLOCK Lone Star Gas Company Wilson Bohannan brand, brass key padlock was designed for and embossed with the Lone Star Gas Company of Texas. Rare find f

 

This is a lot of 4 small sized vintage oiling cans found in my father's estate and consisting of: Two Brass-gold toned cans measuring 2" x 4-5/8" 2-7/8" x 5-1/2" copper plated can with some wear of th

 

Offered for your bidding consideration is a very nice general purpose smoothing plane made by Stanley, Model No. 3. This little guy is shop ready. The iron (cutter) has a clean sharp edge. Everything