This is 3” high x 1 ½” dia. at the base. It is made of brass. At one time it had a nickel plated coating on it, but over time and use this has worn off in spots. Pic is enlarged several times to

 

This is a very unique ball pein hammer marked Niagara 4 in good condition with normal and very clear logo. The handle looks original to hammer and is also in good condition with normal wear. The hamme

 

Grovelodgeuk Store Old fine natural oilstone, in a craftsman case, I am not sure what stone it is, light brown in color with a yellowish tint. The actual stone 5 inches long and 1 5/8 iinches wide, it

 

26 Assorted Wood Carving Chisels and Gouges from an estate sale. There is a set of 10 Tombo-Trademark-Japan, a Buck Bros. Gouge, a large Whitherby Gouge 1" wide, 2 Millers Falls Gouges, 2 Stanley chis

 

Grovelodgeuk Store Old Prory tinmans rivet set or snap it is 4 3/4 inches long with snap 1/8" rivets, the dome is 3/16" in diameter.

 

This is for a lot of 4 antique iron block planes see photos 1 - Stanley No. 9 1/2 measures 6 1/4 x 2, good condition has all parts 2 - Sargent No. 5307 measures 7 x 2, very good condition has all part

 

Three tool bits for a Stanley model 130-A spiral ratchet screwdriver, and other similar tools by Stanley, Millers Falls, etc. The important point to know if these will fit your tool is the shank diame

 

5 SNAP - ON DRIVER TOOLS IN NICE CONDITION, FIRST IS A PHILLIPS No.1 STUBBY SCREWDRIVER SSDP-21, NEXT IS A No.1 SLOTTED SCREWDRIVER, No. SSD234, THEN A T15 TORX DRIVER, No. SSTX415, THEN A 1/4" DRIVE

 

timtarrant08 store Skeleton Victorian Art Fashion Big Engagement Part Component Setting Skeleton Keys Vtg Antique Craft Crafts Charm Charms Gift Bead Beads Steampunk Lot Bulk Replica Reproduction Coll

 

Vintage Auger Drill Bits. There are different makers there are Craftsman / Irwin / Snell Fiskdale, Mass / one I saw was made in west Germany. There are ones that I can't read what it says . But these