Storage Capacity: 8G 70mm x 35mm (1:1) Swing open ★Shipping & Payment - We Will Arrange Shipment For You Within 24 Hours After Payment Received. - The All Shipping Projects Can Provide a Trackin

 

I AM LISTING A GREAT OLD VINTAGE CAST IRON AND WOOD BARN PULLEY. IT MEASURES ABOUT 11 " TALL AND 6 1/2" WIDE. THIS PULLEY HAS BEEN CLEANED AND SPRAYED WITH A CLEAR LAQUER TO PRESERVE THE ANTIQUE PULLE

 

How wonderful is this? An antique wood MORTICE chisel made by Marples , Sheffield, England. In incredible condition and has great transfer badging still in tact. Measures 37cm long. The blade is 1.4cm

 

VINTAGE BELKNAP BLUR GRASS LOUISVILLE CHIPPING HAMMER HEAD

 

Up for auction is this vintage hatchet/hammer. The piece is in pretty good used condition, minor surface rust and a few small chips on the edges, you can probably see them in the photos. The piece is

 

RARE "GREEN & MENGEL" Cone Mandrel Hardy... Here is the Highly Sought after cone mandrel hardy produced by Green & Mengel, these cones are one of the best made.. This cone has seen very little

 

VINTAGE! CLASSIC!AMERICAN MADE QUALITY! MANUFACTURED BY;SNAP-ON TOOLS CORPORATIONKENOSHA, WISCONSIN, U.S.A. PART NUMBER KRA-104 DATE CODED 1980 BOX OUTSIDE MEASURES:14 X 5 1/4 X 3 1/2 INCHES FLIP-LATC

 

Welcome to TNGTOOL'S Sunday night at 8PM, 7 day auctions. Last weeks auctions auction close one minute apart and new ones begin. Auction's starts at 8:00P.M. Eastern time. A new auction every minute.

 

Check out the pictures below, for some auctions there may be more than shown above. Marked on the back KEEN KUTTER and 9 for the 9 inch blade length. A little light surface rust to clean off and a sha

 

Stanley plane no 3 sweet heart in good condition. No damage to the plane other than some minor varnish lifting on the knob and tote as well as some scuffs that you would expect to find with a vintage