Nice vintage copper and brass spatula. Solid rivets, not loose or rattly. Nice patina, would clean up easily if you want it shiny or for your morning eggs. 16 1/2" long, 3 1/4" wide. Nice heavy solid

 

This Eico amp has been in my possession since the 70's. It was installed in a Leslie 122 that I bought. I have been amazed by the power of this thing! Tons of bass, low noise, amazing power, and zero

 

Here is what I know. The tuning needle is missing, but presumably inside the case, on the bottom. The tuning string must be broken, because the tuning dial just spins and spins. I did not try hooking

 

TONIGHT WE HAVE A MAGNAVOX 88-02 POWER AMP  A PUSH PULL AMP WITH 12WPC  4 6V6 TUBES 2 6EU7 1 MULLARD RECTIFIER TUBE  NEW POWER SWITCH UPGRADED SPEAKER CONNECTION NO HUM  FREE SHIPPING WITH FEDE

 

Newcomb tube amp with an el84 power tube believe it or not sounds like a mini Marshall. Vintage amplifier with 1/4" input for running a mic or guitar. Speaker is a 9"x6" alnico Newcomb labled Rola spe

 

RED AT&T PHONE Vintage Telephone grey push buttons 1980's I think (cannot make out the whole date) mostly clean with less wear than normal but still has slight scuffs, handset dust

 

scoutsattic Store FOR AUCTION *** .99 START NO RESERVE ***Bid with confidence. We have a proven track record of successfully packing and shipping fine antiques and collectibles. This will be packed wi

 

1970's full set of original knobs from a Fisher receiver

 

 

Hello there,up for your consideration are 11 12Ax7/ECC83 short & long gray plates,American & Japanese made,there is no original boxes for them but they will be very well packaged for shipping.