The anvil itself weighs about 15 1/2 pounds ON MY BALANCE BEAM SCALE. , SOME EDGE MARKS BUT NOT BAD . The face is flat again some hit marks . This well made little anvil has both Hardy and Pritchel ho

 

CUSTOM Raised Arch Tinsmith Stake... Here is a custom made one of a kind Tinsmith stake that is work ready... The stake is in excellent condition and has been well cared for.. The working surface is s

 

Up for Auction is Vintage Ford 9 inch Mechanics Wrench circa. 1920s - 1940s. This wrench has been used and still has good knurl and gear threads. There is some wear to the moveable lower jaw. The jaws

 

Nice original Proto soft face hammer with the original handle. The hammer is about 12 inches long. The head with the tips measures about 3 1/2 inches wide. The chrome is nice. Still has nice green pai

 

Here is an old North Bros Yankee screwdriver. No. 105. Has the following dates stamped on it. Pat. Nov. 2 97 and May 1-06-May-15. I have not cleaned or polished item. It is in found condition. Works f

 

Vintage hand forged tomahawk style hatchet..looks to be blacksmith made..I believe it is Austrain is was quite common in Austria for Blacksmiths to strike touch marks into their work..the marks on thi

 

UP FOR BID: ONE VINTAGE 1950s STAR HEADLIGHT AND LANTERN CO. NY. FLASHLIGHT. THIS BLUE LIGHT IS 7" LONG AND IS 9" TALL WITH A 4 1/2" ROUND LENS. NOT TESTED HAS RUST SOLD AS IS. WILL PAINT UP NICE.

 

Up for Auction: Made in the U.S.A. 6" Low Angle Block Plane with Stanley Blade. The plane is in very good condition, ready to use with slight sharpening of the blade.

 

Up for grabs is bad ass little fully custom NOMAD style fish bat or tire tumper that has been all hand turned by me,....You are buying this piece directly from "Uncle Pimpys Axe Palace" and this is al

 

Blade is Veritas PM-V11 never been used or sharpened