toolmusic store Antique Tenon / Back Saw :::: HENRY DISSTON & SONS . PHILDA . CAST-STEEL . WARRANTED . 12" Blade / 13 TPI . Good Used Condition ..... Buyer Pays All Shipping & Insurance Sold "

 

Vintage Stanley router plane no. 71. Based off of the picture in the directions it is complete. Has box which is in bad condition and the directions sheet. Has spots of rust (especially on two of the

 

PLEASE SEE MY OTHER AUCTIONS FOR A LARGE SELECTION MACHINIST ITEMS, I WILL COMBINE SHIPPING. Used. . ... . . . . . . . . . . . ... .. .. .. .. . . . . . . . . . . . . .. . . . . .. . . . . . . .. . .

 

RARE VINTAGE SNAP ON TOOLS 8 POINT 1/2" DRIVE SOCKET SET GOOD BUT 3 ARE RUSTY MOST ARE GOOD 3/8" 7/16" 1/2" 1/2" 9/16" 5/8" 11/16" 3/4" 13/16" 7/8" 15/16" 1" ARE TWO 1/2" ONE IS RUSTY.

 

dreamsfound Store This is a near mint vintage Pelouze R-47 scale complete with two pans and 6 brass weights - it also has the original box with instruction card. The weights are 1, 2, 5, 10, 20, and 5

 

This is a vintage HB single bit axe head that is made in sweden and in good condition and free of wood. It is 6 7/8" end to end and 3 3/4" at bit. The head weighs 2 lbs 5 ozs I took several close up p

 

LARGE ROSEWOOD SLICK CHISEL HANDLE OLD TOOLS FOR TIMBER FRAMING 17" long overall - unused old stock handle tapers down to 3/4" on the small end Check out my other items!

 

A large vintage Brass Mounted Steel Padlock, with a single working key. The swivelling keyhole cover is marked “Improved Tumbler Lock”. It measures approx. 4 1/4” x 2 ¾” x 7/8” overall. The

 

Up for bid is a USED VTG Electric STANLEY Drill #DC8313N -1950S Era Volts 115CAP 1/4Type 142RPM Load 1000RPM No. Load 1400With KeyWorks GreatThis is used. Does show some wear from use.Does show some s

 

This auction is for a vintage 11" wooden handle drywall saw with a 6 1/4" blade and a Marshalltown #29 circle cutter. Both tools are in Very Good condition! The gauge on the circle cutter goes up to 1