Condition:Good as Vintage.Blade is rusty and nicked. Please check Photos. It has been worn out for age, so it's hard to show original planing performance. Recommend for Japanese vintage carpenters too

 

Used Garland leather mallet, rawhide hammer No. 5 , Saco, Maine, Wt. 7 Lb.. Nice handle marked BASA No. 5 Very good condition. Email any questions.....I will ship Fast.

 

This is a wood bottom Liberty Bell Fore plane, 20 inches long with a 2 3/8 inch "J" cutter. The name and number on the front of the plane are long gone and it would take a vivid imagination to even ma

 

old. other than the information I found from a quick net search I know nothing about the saw. overall length: 15" blade length: 10" back length: 9 5/8" a rivet is missing from one side of the handle.

 

Branding Iron – I’m pretty sure this branding iron was designed to rest atop a blowtorch for heating, although I suppose it might have been inserted into a charcoal or gasoline furnace. The total

 

· Good Working Condition · Patent Date: 8-22-15 · Still Retains Most of the Original Japan Finish

 

getting both of the old pexto draw knifes

 

Fresh from old local estate of pattern maker comes these Buck Bros and Brothers chisels. 8 total . Sizes are from largest to smallest : 1 1/2" ; 1" ; 7/8" ; 5/8" gouge ; 5/8" bevel back ; 1/2" ; 7/16"

 

Vintage hand drill including 4 bits, no visible maker marks, approximately 11" long, good condition, storage in handle, aluminum crank knob seems to be added, please use pictures as part of the descri

 

Stanley Tools Description Nice parts or restoration lot of Stanley woodworking tools. Two 45 frames, some parts, each has handle issues, see pictures. Decent 78, near all there? 192 with cutter and ca