This scraper is a variation on two others I have found previously. This example features a hammer head on top, the previous two I found did not. See the last two photos for the previous two examples I

 

i000000 Vintage Small 1/4" No: 5 or 6 IC Carving Gouge Tool by I SORBY vgc Old Tool Click Images to Enlarge You are bidding on a vintage 1/4" Beech Handled IC Small Carving Gouge by I SORBY in good co

 

Vintage Rare Leatherworking Plough Gauge by George BARNSLEY vgc Old Tool Click Images to Enlarge You are bidding on a very rare vintage Leatherworkers Plough Gauge by George Barnsley in very good cond

 

Makers name overstamped. To cut a a 1/4" cove. Some bruising to the heel and wedge, otherwise good. Stamped 5/8 and 4/8 on the heel (?)

 

For sale - Beads pair - Uncommon smaller design as shown - sizes 1/2 inch and 5/16 - Standard sized plane is H. Chapin - Questions welcomed -

 

Three tool bits for a Stanley model 130-A spiral ratchet screwdriver, and other similar tools by Stanley, Millers Falls, etc. The important point to know if these will fit your tool is the shank diame

 

WINCHESTER Shears, 1 pair Bent Trimmers #9053 6 inches....1 pair Shears Straight Trimmers #9010 6 inches Bent pair has Winchester on large loop blade, straight pair doesn't...........sell together Goo

 

VINTAGE BRAIDED 5/8" DIAMETER BARN OR NAUTICAL HEMP ROPE WITH PAIR OF IRON DOUBLE PULLEYS. THIS ROPE WAS BARN STORED AND HAS A BIT OF A MUSTY ODOR SO IT COULD USE SOME SUNSHINE OR A GOOD CLEANING. IT

 

Set of 3 CRAFTSMAN #2993 / 92993 / 18112 Planer Cutters / blades, 6.5" X 11/16". They came in a hand wrapped package marked "sharpened" - and sure enough they are razor sharp with clean edges with no

 

Carpenter Saws Two older Simonds saw tool pocket guides. Probably 1920's era, but I did not see any dates. One book has a textured cover, both are about the same on the inside. Many picutres and descr