THE HORN HAS TO BE BRASS OR BRONZE ...THE BASE IS CAST IRON. I AM NOT TO SURE WHAT IT IS AT ALL. FRESH PICKED. IT IT ABOUT 10 1/2" TALL WITH OUT THE MOUNTING SCREWS ON BASE. THE BASE IS ABOUT 5" X 5".

 

New and Un-Opened - slightly crimped edges. No defects.

 

UP FOR BID IS A VINTAGE BRADFORD POCKET TRANSISTOR AM RADIO . MADE IN HONG KONG. THERE ARE SOME SCRATCHES AND NO CHIPS OR CRACKS. IT HAS BEEN TESTED AND SOUND GOOD. TAKES 9 VOLT BATTERIES ( NOT INCLUD

 

This my Revox which I have owned since 1975--I am the second owner. The deck has been well maintained and cared for over the years. I last used it in 2011 to transcribe a few open reels from 1978 to C

 

This auction is for a EICO Tube Tester 625. It is being sold AS IS! I have no idea if it works or not. Its been sitting in our garage for a long time. It used to belong to my grandfather and I have no

 

This is a nice used Kenwood Receiver wood case. It came on a KR-5150, but I'm willing to bet it will fit other receivers. I can provide dimensions if anyone would like. The feet are new, replaced by m

 

Selling the "made in Berkeley California" Legend Audio Starlet tube amplifier serial # B04-00127 which is 20 units away from the unit tested in this Stereophile article. Works fine. I have newer audio

 

THIS IS USED CARVER 4 CHANNEL AMPLIFIER, ITS IN GREAT CONDITION. IT'S HAS FIVE CHANNEL POWER AMPLIFIER: A) FRONT CHANNEL: 100 WATT B) REAR CHANNEL 50 WATT C) CENTER CHANNEL 110 WATT ALL CHANNELS WORKI

 

USED BASF 10.5" REEL TO REEL RECORDING TAPEMETAL FLANGE, MODEL 911 BY EMTEC

 

This is ONE WONDERFUL, TOTAL MINT and ENOUGH RARE, TELEFUNKEN branded, COUPLE of single TRIODE EC8010 = 8556 NOS/NIB made by SIEMENS-RöHRE (from bulk-carton and boxed), genuine made in GERMANY. Super