This machinist's level is early (pre-1907), rare, and struck with the "C.F. Richardson" "Athol, Mass" trademark. It retains ~70% or more of its original japanning and bears an uncanny resemblance to a

 

NEAT 2 Lb Repousse Hammer.. Here is a nice hammer to habe around any panel beating shop... One of the hammer's ends is slightly raised dome shaped, its in good condition with few dings from use, measu

 

HERE WE HAVE A REAL NICE EARLY STANLEY NO. 83 CABINET SCRAPER. ORIGINAL ROLLER. DATED 1925 - 1935 WITH A 3 7/8" SCRAPER BLADE. THIS WOULD MAKE A GREAT ADDITION TO YOUR COLLECTION. AND YES WE ARE START

 

RARE IMPROVED CHAMFER PLANE BY MOSELEY WITH CAST IRON SLIDING BOX 6 1/4" in length, 2 5/8" wide. Toe stamped JOHN MOSELEY & SON, 54 - 55 BROAD ST., BLOOMSBURY, LONDON. Iron stamped JOHN MOSELEY &a

 

FROM A LOCAL ESTATE. EXCELLENT CONDITION. NO RESERVE.

 

The saw has the rare shallow wheat carving done in the 1880's and its in really good shape but I did have to repair the top horn and it has thouse really big owners marks. It is 18" long x 5 1/2" x 2

 

This listing is for a Craftsman screw-out set. These bits are designed for removing worn stripped screws. The set was senior owned and show little if any use. The bits come with the original paperwork

 

This auction is for an old vintage ring-nose blacksmith tool The tool is used, shows wear but is in good condition. 14-1/4" long. Nice old collectible tool. Comes as seen in pics. Thanks for looking a

 

vintage drill bit holder from the Cleveland Drill bit company. Ready for your collection or work

 

VINTAGE FORD SLIP-JOINT PLIERS Length: 6-1/2" approx. Has Ford logo marked on them; also a mark on the inside which I'm not sure what it is . Made of steel; btm. end on one side is for use as a screwd