****NO RESERVE***THREE DAY AUCTION*** WHAT A BEAUTY measuring approximately 24" X 2" X 1", this Model 11 Stratton Brothers level is about as good as you can find them. Both glass tubes are full and th

 

Please see photos. 1950's era Craftsman table saw model 113.27520. Email with any questions. Pick up only and within 72 hours of winning bid or purchase. 

 

Antique hammer, one piece head and handle forged steel, with attached bolstered wood handle. 10 5/8" length to end of handle. 6 7/8" length from claw to face. Very good antique condition with wear con

 

MADE IN JAPAN.It was made with ebony Length:360mmThickness:28mmx 20mm Please let me know if there is any question. The shipping cost is $20.

 

Up for auction! - - - - - LOT #13-0008 for your consideration and perusal - - - - - - American U.S.A. BRASS PADLOCK - with KEY Junkunc Bros. Imprinted on front of lock (AMERICAN over U.S.A.). Imprinte

 

This machinist's level is early (pre-1907), rare, and struck with the "C.F. Richardson" "Athol, Mass" trademark. It retains ~70% or more of its original japanning and bears an uncanny resemblance to a

 

SOLID BRASS , SCREW ON FRONT BEZEL, app. 6" ROUND, WESTINGHOUSE-WILMERDING PA. U.S.A...BY THE STAR BRASS MFG. CO. BOSTON, LOOK AT PHOTOS, sold as is

 

nice lot of antique skeleton keys, mixed condition. see photos.

 

Up for auction without reserve is a Bailey plane iron in pristine un-used condition. The plane iron has been sitting on a shelf for nearly 150 years in an old building until I found it. The plane iron

 

For your consideration is this set of older brass Jailer's Keys.The set consists of 5 keys on a large ring.The keys range from 3 1/8 inch to 7 inches long.The total length is 12 1/2 inches long X 4 3/