NICE 2 1/2 Lb Cross Peen Hammer... Here is a great all around forging hammer for general use.. This hammer is in excellent condition and work ready.. the hammer's face is flat and smooth without chips

 

SINGLE BIT AXE 7 3/4" X 4 1/2", 4 lb. approx. with logo ( VAUGHAN VALUE BRAND ) A few light scattered pits and or buildup and use marks. Hammeroll correction grind marks on poll. Paint remnants. Edge

 

Up for auction is a vintage brass key in as shown as found condition. Not sure just what it was for. The end has a square hole so it may have been some sort of key. Found hanging on the wall at the es

 

Vintage STERLING Pocket VOLTMETER #44 0-10v Gauge Hot Rat RodThis is a vintage Sterling Pocket Voltammeter. It is in the original box with instructions and a wire to attach it to the car. It is Model

 

You are bidding on 2 sliding breaker bar ratchets. Both in good working condition. The chrome is chipped off slightly on the 1/4" drive, but the 3/8" drive does not have any chips. There is an engravi

 

This is a vintage single bit axe free of wood. It is 6" end to end and 3 7/8" at bit and weighs 2 lbs 5.5 ozs Please refer to close up pics

 

This is a very unusual, but very decorative silversmithing hammer! The hammer is in great condition! The handle is crack and chip free and there is only a slight wiggle at the head. It's unmarked too.

 

This auction is for a vintage Penncraft Socket Flex Head Ratchet. The tool is used, shows wear, scuffs, dings and scratches from age and use but is in good and working condition. The flex head is a bi

 

Tremont Square Head Nails. You will get approximately one pound of each of the following: 7/8" headless brads, 1 1/4" common, 1 1/2" common, and 2" common nails. Bought for projects but ended up never

 

This is a vintage brass hand pump that has been painted or restored. It pumps easily in and out and is not stuck, not quite sure how to use it though. It stands 25 1/4 inches tall and extends out to 4