toolmusic Store VINTAGE "PEXTO" FOLDING HANDLE DRAW KNIFE W/ 9" CUTTING EDGE .-. Very Good+ Used Condition .... Buyer Pays All Shipping & Insurance Sold "As Is" - No Returns

 

Up for bid is an Antique Barn Peg Beam Hand Cranked Auger Drill Wood Handle 1.5" Diameter x 18.5" Long. Back in the day when you built a building there were no nails or they were very expensive, so co

 

This very small level is 3 inches long by 2 inches high. The three levels are all good. It shows some use but it is a nice little level. Buyer pays actual shipping. Shipment to USA and Canada ONLY. In

 

Dad is downsizing his antique scale & measures collection. Up for auction is a vintage brass postal scale with 3 stacking weights. Please note on the left side the piece that attaches to the under

 

budgie2cheap Store An old 10 tpi saw by Disston,Philadelphia.good teeth,quite sharp,would benefit from a final honing.all nuts present,some splashes of paint on handle,but solid with no breaks.straigh

 

A very nice PECK STOW & WILCOX folding handle drawknife. This tool is marked P.S.&.W. No. 1. EX. 10 IN. The full length of the blade is 15 3/4" and the cutting part is 10" long. From the top o

 

SNAP-ONA 14 INCH LONG EXTENSION FOR 1/4" SOCEKTSTMX 140IN VERY GOOD CONDITION.

 

you will be bidding on a vintage set no.5 drill bit holder made by THE STANDARD TOOL CO. of cleveland ,ohio,made of cast,has 29 holes,1/16 to 1/2",in good condition for its age,does have some age crac

 

Here is a vintage True Temper Kelly Works fire ax head. It would be good to add to a collection or with a new handle it would be as good to use. It weighs about 5 3/4 pounds. It is about 12 inches in

 

Old brass weight set latches shut, and contains 4 nested "tubs" inside main vessel. I don't know weight of holding vessel or largest insert. Second largest insert cup is stamped 2, and third one in is