Up for auction is this nice, well made old hardy for a blacksmith anvil. Measures approx. 4" long overall; shaft measures approx. 1" across (made for a 1" hole). Looks like the shaft has been shimmed,

 

In this auction you are bidding on : .....VINTAGE SNAP ON TOOLS 1/2“ DRIVE RATCHET ADAPTER - EXCELLENT.... Made by Snap On Tools, USA. Snap On Tool Number 67 - B. PAT. NUMBER 2020883. Used to change

 

Vintage STANLEY #61 Boxwood & Brass Carpenters' Folding Ruler This is a 24" vintage STANLEY No. 61 four-fold boxwood and brass Carpenters' rule with square joint. I rate this ruler in GOOD CONDITI

 

The anvil itself weighs about 15 1/2 pounds ON MY BALANCE BEAM SCALE. , SOME EDGE MARKS BUT NOT BAD . The face is flat again some hit marks . This well made little anvil has both Hardy and Pritchel ho

 

This auction is for a lot of five vintage skeleton keys. Authentic antique iron keys, old and rusted with age. These skeleton keys vary in size from 1.5 inches long up to 2.75 inches long. Five keys w

 

AS SHOWN....REAL NICE SHAPE AND UNCLEANED....HARD TO FIND TO SAY THE LEAST........NOT SURE OF THE PURPOSE BUT I AM THINNING OUT THE HARDWARE STOCK............I HAVE ALL THE PARTS FOR PLANES AND OTHER

 

Very nice working plane could use minor cleaning .Close to 100 years old . Nice sharp blade , ready to use. Or nice display piece for the old tool collector. Shipping will be $14.00NO INTERNATIONAL SH

 

Up for bid is this older Fulton Tool Co. adze head. Blade width is 4'', overall length is 9 1/4''. There is a oval on inside of blade with two little stars in it and reads FULTON TOOL CO. MERIT MARK.

 

This is an old tool catalogue from 1897 put out by Montgomery & Co., New York City, New York. It is catalogue No. 21. The covers on this book are worn and soiled as seen in the photos but are not

 

8 inch folding handle draw knife stamped - L.JENNINGS PATENTED FEBRUARY 20 1906. Also has Jennings logo - arrow with J inside. Used tool but still very usable - good condition. Posted with eBay Mobile