Mismatch of good tools. Total of 17 pieces snap on consist of 6 pieces; 1/4" Snap on Rachet MIDGET M-70L (handle repaired excellent) 3/8" Rachet F730 (missing reverse lever) 1/4" speeder handle 1/4"x

 

Vintage SATER BANKO Double Bit AXE made in SWEDEN. Well marked, clean and sharp axe. Head measures 10 5/8" long. Clean and sharp. The handle is 33 3/4" long, marked SUPERIOR, and has no breaks or chip

 

Bending fork anvil hardy tool for 3/4" hardy hole This bending fork hardy tool is made from 3/4" round C1055 carbon steel. It is tough and will hold up well to bending hot metal. The forks are spaced

 

FOR SALE A NICE SET OF OPEN END SNAP-ON WRENCHS.1"-15/16 , 7/8 - 3/4 , 13/16 - 11/16 , 11/16- 5/8 , 1/2 - 9/16

 

Adze is in good solid condition. Just has been rusty. I buffed it out and oiled. I think it has original handle. I can't see any markings.

 

UP FOR YOUR AUCTION APPROVAL Description This is a vintage plane in very good shape. The nickel plating is good, shows some age but even that is minor in my opinion. Also at the last minute before lis

 

I have for auction these two vintage lakeside carpenter chisels. the large one is a 2'' wide chisel. and it is 15 inches long including the handle. The second chisel is also a lakeside . It is 1 3/4''

 

This Winchester plane is #W220.7 inches long"Winchester" on top edge of bladeQuite nice condition.Small flat rate box.

 

This is a small but heavy (2 lbs.) machinist's vise by Joseph B. Fakes & Co. Royal Oak, Mich. Jaws open to 1.25" or 1 1/4" one jaw has a V channel. The vise closes tight, is not loose and turns fr

 

This listing is for a 12 point, Snap-On-Tools,OEX20A, 5/8" combination wrench in very nice used condition. This tool measures 9 1/2" long. Thank you for looking.