A very nice Cast Iron Block Plane with the original cutting iron and wood wedge. The Plane is 5-1/2 inches long X 2-1/4 inch wide X 1-1/2 inches high. The body of the plane has no rust and the japanni

 

This auction is for a vintage Stanley 110 block plane in it's original box. This is a lightly used plane in excellent condition. Please feel free to email any questions. Low opening bid! Dimensions: 7

 

woodside1 store 1950 VINTAGE HOW TO RUN A LATHE SOUTH BEND LATHE WORKS ILLUSTRATED MANUAL You are bidding on a Great Looking ORIGINAL 1950 Vintage How To Run A Lathe, published by South Bend Lathe Wor

 

Vintage Cast Iron Stanley Wood Scrub Plane No. 40 Plane belonged to my grandfather who passed away in 1972. I don't know dating of plane, but he would have used it anywhere from about 1920 until the m

 

STARRETT WHEEL CHART TAP DRILL DECIMAL CONVERSION. COPYRIGHT DATE 1949. IN GOOD USEABLE WORKING CONDITION. SHOWS WEAR FROM USE AND AGE. THANKS FOR VIEWING.

 

Up for bid is a USED VTG Electric STANLEY Drill #DC8313N -1950S Era Volts 115CAP 1/4Type 142RPM Load 1000RPM No. Load 1400With KeyWorks GreatThis is used. Does show some wear from use.Does show some s

 

RARE "GREEN & MENGEL" Cone Mandrel Hardy... Here is the Highly Sought after cone mandrel hardy produced by Green & Mengel, these cones are one of the best made.. This cone has seen very little

 

ALL THE SOCKETS ARE SK 1/4",3/8"& 1/2"DRIVEALL THE WRENCHES ARE SKALL THE CRESCENT WRENCHES ARE CRESCENT WRENCHESALL THE PLIERS ARE CRESCENTMOST OF THE DRIVERS ARE KLEIN IF FOR ANY REASON YOU ARE

 

VINTAGE FORD SLIP-JOINT PLIERS Length: 6-1/2" approx. Has Ford logo marked on them; also a mark on the inside which I'm not sure what it is . Made of steel; btm. end on one side is for use as a screwd

 

Two (2) Hargrave "Superclamp" Cincinnati Tool 6" No. 44 C-Clamp This pair of c clamps are in good working condition. They show some wear, surface rust and needs some oil.