THIS BALL PEEN HAMMER IS IN GREAT SHAPE THIS MEASURES APPROX 8 AND 1/4 INCHES LONG.EMAIL ME WITH ANY QUESTIONS.

 

Up for auction is a 1.75 pound hand forged blacksmiths raising/repousse sheet metal hammer. This hammer was hand forged from 1045 steel using a coal fired forge. It has been properly heat treated and

 

New Old Stock Craftsman Ratchet. Slim & Offset head for those hard to reach spots. Built in thumb spinner & padded comfort grip. Quick release ratchet head. This is a Pristine Collectable ratc

 

This Stanley Sawset 42W is used showing some wear but in good condition. Please see the pictures. I took a lot so you could see everything. It has a blue finish, a little rust (see pictures).

 

This auction is for 3 old cast Iron Sprockets. The two that are matching have a diameter of 7" not including the teeth on the sprocket. The single has a diameter of 6 1/2" not including the teeth. Ple

 

Lot of Vintage Engraving Repousse Tools DESCRIPTION: Lot of 100 assorted unique vintage engraving tools. These antique tools were used by a Master Engraver between 1950 and the Millennium, prior to re

 

ANTIQUE 2 # 13 OZ FORGED STEEL BLACKSMITH'S SLEDGE HAMMER HEAD - 8 SIDED STRIKER EACH END - MARKED FORGED STEEL AND A NAME WHICH I CANNOT MAKE OUT - HAS A "8 OZ" MARKED ON IT BUT ACTUAL WEIGHT IS 2# 1

 

RARE C&L No. 6 Blowtorch – This quart-size, bottom-fill, gasoline blowtorch was manufactured by the Clayton & Lambert Mfg. Co. of Detroit, Michigan. The tank is made of brass, as are the pum

 

Blacksmith Hardy hole tool..About 8" long with a tapered shaft from 3/4" to 1" has a roundish ball on the end...HONEST, OLD, AND FRESH TO THE MARKET...

 

Hi!Thanks for looking! All of the things i have for sale are as found and need cleaned. the bigger one is about 8 1/2" long and opens to 1 1/4".The smaller one is about 7 1/2" long and opens to 1".The