ALL MADE IN THE USA EXCEPT THE LAST TWO PICTURESTHE 1/2"DRIVE RATCHET IS ACTUALLY A EASCO TOOL THAT IS THE EXACT SAME MODEL AS THE CRAFTSMAN IF FOR ANY REASON YOU ARE NOT HAPPY WITH YOUR PURCHASESEND

 

This is a 1.75# rounding hammer forged from 1045. Face are  1 1/2". Flat face is gently crowned and the rounding face has a squashed ball radius. This hammer is balanced. Hardened and tempered for to

 

USED TO DRILL THE HOLES IN THE BEAM TO DRIVE IN THE WOODEN PEGS. UPDATED INFORMATION: THE HARDWARE SPECIALTY M'F'G CO. SOLE MFRG ANDERSON IND. THE PAT BOSS DEC 19 MCH 1882

 

5 OF THEM HAVE CURVED CUTTING EDGES AND THEY RANGE FROM 3/16 INCH TO 1 INCH WIDE. THE OTHER TWO ARE 1/4 INCH WIDE AND 5/8 INCH WIDE. THEY ARE ALL MARKED BUCK BROS. THE LARGEST CURVED ONE HAS A CHUNK O

 

COLLINS FIRE? AXE HEAD, WEIGHS 4 LBS, IN EXCELLENT CONDITIONTHANKS FOR LOOKING

 

Brand new high quality vise. I never opened it so didn't get to see how nice it is. Can't find much info on it.

 

Branding Iron – I’m pretty sure this branding iron was designed to rest atop a blowtorch for heating, although I suppose it might have been inserted into a charcoal or gasoline furnace. The total

 

toolmusic Store VINTAGE "PEXTO" FOLDING HANDLE DRAW KNIFE W/ 9" CUTTING EDGE .-. Very Good+ Used Condition .... Buyer Pays All Shipping & Insurance Sold "As Is" - No Returns

 

One set of Eclipse no 33 trammel points, made in Sheffield, England, points only are 4-3/4 long. I have been collecing woodworking tools for many years, and it is time to start making some room in my

 

THERE IS A SLIDE BAR TO THE RIGHT OF THE PICTURES THAT YOU CAN SLIDE DOWN TO SEE ALL!   I accept Checks but I prefer Paypal.  Thank you for bidding and good luck You are about to bid on aRARE VINTAG