Here is a L.S. Starrett Combination Square Set. Looks to be 3 tools in one. Has a 3 inch rule with two sliding attachments. All three are marked Starrett and are in excellent condition. Made in the US

 

This auction is for an old vintage ring-nose blacksmith tool The tool is used, shows wear but is in good condition. 14-1/4" long. Nice old collectible tool. Comes as seen in pics. Thanks for looking a

 

no markings, in great shape. no warping or writing,used by a jeweler watch reapair craftsman, not abused.

 

Here is yet, another great lot of 8 vintage and newer hammers in different forms for your silversmithing, blacksmithing and general metalworking needs. Using the 1st photo, from left to right, here is

 

This is a front knob and fixing screw for a stanley defience 14" inch jack plane, it has a bit of the finish marred as you can see in the pics.

 

OLD CLAYTON & LAMBERT HAND HELD BLOW TORCH . IT STANDS 10.5 " TALL AND THE BOTTOM BASE IS 5.75" WIDE. I have not used it no guarantee it will work.

 

Stanley#10 Carriage Maker's SW Plane Description:SW.CA. 1919-322'/8”w x 13” lPlane has no cracks or repairs that I can see. There are some deep scratches on rear of sole probably caused by a nail.

 

This is a nice Buck Brothers No. 9 Straight Gouge 3/8 Inch Wood Carving Chisel This Buck Brothers Straight Gouge Wood Carving Chisel is 3/8 inch wide and 8 inches long. The hardwood handle is in very

 

Very Rare Clayton & Lambert No. 8 Blowtorch, unmarked!! – This self-acting blowtorch was manufactured by the Clayton & Lambert Mfg. Co. of Detroit, Michigan, and dates from July, 1900. To op

 

1" GOUGE TANG CHISEL, POOR CONDITION, HAS A LOT PITTING I ACCEPT MOST FORMS OF PAYMENT I COMBINE SHIPPING WHEN POSSIBLE LOCAL PICK UP IS WELCOME