All antique chasing tools are in excellent used condition.No rust or damage.They are made of tempered tool steel.,the long one is 3 3/4 inches. .All are different) ( Note: All of the Design Stamps are

 

Vintage Brass Ball Peen Hammer. Very clean. No makers mark on tool but it was found together with many other quality tools in the same tool box. Please see all pictures before bidding. Thank you for l

 

Up for bid is this vintage Brakefix Brake Relining Kit by H&R Products Co. Cleveland Ohio. I believe this kit is complete less parts and instruction sheet. The anvil was ground to make it a little

 

For sale a fine looking - early Henry Disston & Sons small dovetail saw - Cutting edge is 10 inches in length - Saw length overall is 15-1/4 inches - Questions welcomed.

 

This is a Lufkin 372 folding caliper ruler. When open it is 12 inches and the brass caliper extends an additional 5 inches. The hinge opens easily. The caliper slides well. The wood surface is stained

 

This is a lot of 5 vintage blacksmith hammers all in good working condition just need handles.All but one has wood in head. 12 lb sledge marked Senior Japan very old and hard old steel 8 lb sledge mar

 

Up for auction is this EAGLE SIX LEVER Padlock. Measures about 2 inches from top to bottom. Opens and closes easily. Please see photos for condition. If you have any questions or requests for addition

 

Vintage Japanese Chisels used by Japanese carpenter!! Vintage old chisels used by Japanese carpenter for a long time. Very old but fairly in good condition.Length (approximately): 7-1/2" (or 19 cm).Bl

 

You are bidding on a large natural sharpening stone in a wooden box. It is cream in colour with a few darker veins and markings. This type of stone is usually combined with a purple stone on the under

 

YOU ARE BIDDING ON: LOTS OF 6 JUNK DRAWER MIXED OLD VTG WOODWORKING HAND SAW ANTIQUE TOOL.THESE ARE GRAND FATHER JUNK TOOLS, PLEASE CHECK THE PICTURES BEFORE BIDDING. I DO COMBINE SHIPPING.