This is pre 1928 Saw! "Traits common to all #7s, and the later D7, were a straight backed blade and a beech handle. "The handle on this, and all Disston No. 7 hand saws were made of American Beech. Mo

 

Full Set 7 Vintage Cornwell 4 Way Angle Head Wrenches I purchased these old Cornwell angle head wrenches from an estate sale. Some have quite a bit of rust or pitting on the shank but the open ends ar

 

You are checking out an antique Stanley No.7 Plane. Farm fresh picked today (4-27-13) It is approx. 21" in length... large and beautiful! There is one very small chip in the handle. I dont know much a

 

This auction is an assorted lot of hatchets. From the left of the first photo. #1 Half broad ax hatchet with a pole hammer end. Unmarked. Handle has damage below head (looks like a chunk was taken off

 

samjoeantiques Store Vintage metal Drill Stand, measuring 6" w x 3" depth, three rows of holes, this will hold sizes from 1/16 up to 1/2" in size. Marked on front Drill Stand U.S.A. The back has two s

 

RARE STANLEY DEFIANCE, 8 inches long looks to be a 3 smoother. There are many Defiance Planes by Stanley but few made like these, most are identified as Handyman type planes. The Frog is permanently a

 

Millers Falls No. 5 manual drill, some rust, some original paint. From the Millers Falls Tool Co. Greenfield Mass. Not locked up, no excessive play, chuck works fine about 13" overall length. Paypal o

 

Good User Plane with minor wear and oxidation. 6 1/4 inches long with 1 9/16 wide Cutter. Photos show condition. Sole and cutter back are lapped flat. Pitting has been honed out in process. Thanks for

 

Not broken excellent condition. 3 different sizes. Thanks for bidding and bid with confidence.

 

In very good, little-used condition.