General Hardwear Mfg. Co. N.Y. Multi gauge. No. 16, 1937. Rule, protractor, square, centre finder, circle divider, drill point gauge etc.

 

Power Steering Pump Pulley Remove & Install Set (PSPKIT) Designed to prevent damage to pump or internal parts. The right combination of tools needed to remove and install a wide range of pulleys o

 

Stanley # 60 1/2 Low Angle Block Plane, USA Made This is a Stanley # 60 1/2 low angle block plane in good condition. It's just over 6 inches long, not counting the knob, and the cutter is 1 3/8 inches

 

used two man cross cut saw handle, the wooden handle has been eaten by bugs. But the metal parts are good. 13 1/2in long handle, 4 9/16in long metal part that is connected to the wood handle, the part

 

This set of Ridgely Graining Combs is in a thin steel case with a gold tone. The case is badly scratched and the label on the back side is partially gone. There are four different width sets: 1 inch;

 

these catalogs have some soling and general wear - creases and deposits on the covers. the most wear is on the 1973 catalog in the lower right corner. also some overall 'waviness' to the catalog. othe

 

Up for bid is a USED VTG Electric STANLEY Drill #DC8313N -1950S Era Volts 115CAP 1/4Type 142RPM Load 1000RPM No. Load 1400With KeyWorks GreatThis is used. Does show some wear from use.Does show some s

 

floats Dimensions: Blade 0.3cm PAYMENT PAYPAL (Please pay within 5 days of winning the auction. I will try my best to ship within 1 working day of payment being cleared). If you cannot make immediate

 

You are bidding on a VINTAGE BUFFALO FORGE COMPANY CATALOG NO 183 BUFFALO, NEW YORK. Buffalo Forge was THE blacksmith company for "Forges, Fans, Drills, Hand & Power Blowers, Punches & Shears,

 

Up for auction is a vintage brass key in as shown as found condition. Not sure just what it was for. The end has a square hole so it may have been some sort of key. Found hanging on the wall at the es