Offered is a lot of alligator wrenches . these have pat dates of 1906. one of them reads the K & B CO. the others have writing however i can not read it. these will all be wrapped to ensure safe a

 

RYOBI Detail 6-Pc. Chisel SetFor use with Roybi DC500Kit includes:3mm Groove Chisel7mm Groove Chisel6mm Flat Chisel4mm Skew Chisel4mm Deep Gouge Chisel 8mm Shallow Gouge Chiselp/n 470050Storage box wi

 

Up for bid is a TRUE TEMPER two pound Hatchet Head No. TB2. The cosmetic condition is as seen in the 8 pictures and includes all imperfections seen and unseen. Will only ship to the 48 USA and will on

 

4 new hand forged blacksmith tongs. Tongs are forged from A-36 steel and made to fit 1/8", 1/4" and 3/8" flat or square stock respectively (flat jaw tongs) and the bolt tong is sized for 1/2" square o

 

VERY COOL - VERY OLD SCHOOL .... VINTAGE OLD METAL TOOL BOX ... BOX IS OLD, I DO NOT KNOW WHEN THE OLD SCHOOL PIN STRIPING WAS DONE ... OPENS AND CLOSES GOOD, LATCHES WORK, > NO KEY < ... BOX ME

 

measures 8" long x 2 1/2" wide........the cutting iron, and cap iron, measures 1 7/8" wide and have no rust or pitting...!!!........marked with the Moulson Bros logo.......has a thin piece of wood, pe

 

Offered up here is this this old hand cranked bench grinder. Good used condition not abused. Wheel on it is about 3 5/8" diameter, 1" wide. Maximum tabletop/benchtop clamp opening is 1 3/4". Works gre

 

UP FOR BID I HAVE A PLUMB DOUBLE BIT AX HEAD. THIS HEAD MEASURES 9 7/8" LONG, IT HAS 4 3/8" BLADES. BLADES DO HAVE SOME CHIPS (SEE PICTURES) THERE IS SOME MINOR PIN PRICK PITS. DOES HAVE A NICE DEEP P

 

I think it's a 65, but don't know for sure. From an estate. Missing the front adjustment lever and screw. Front portion of the base is movable and will move. Light surface rust on the base as shown. N

 

This auction is for an antique 24" cast iron level made by L.S. Starrett, I think? I don'e think it is marked, but it is like Sterrett levels I have had in the past.. It is missing one of the glass bu