The item you are bidding is a scroll starter used buy blacksmiths to start the delicate ends of a scroll. The tool you're bidding is 3 3/8" long and 2 3/4" wide and aprox. 1" deep. This is a very usef

 

This is for this billhook as shown and as you can see it's in great condition and very well marked.The bolted on piece can come all the way off and it's adjustable.I do have the original axe looking h

 

SMALL BENCH VICE FOR JEWELLERS OR SILVERSMITHS ETC MADE WITH HAND RIVETS MEASURES 9 CM LONG. THE JAWS ARE 27mm LONG & 8 mm DEEP THE VICE CLAMPS NICELY BUT THE BENCH ATTACHMENT SCREW IS WORN SO IT

 

This Auction is for A 9" Antique Draw Knife The only markings I saw on it were in the middle of the blade "Oak Leaf" "Made in U.S.A." Blade is 9" long and total length is 14 1/2" long. There's a coupl

 

Simmons Hardware Company Padlock Lock with key. This lock is a push key type with the key, it works great. Lock is made of Cast Iron and bronze. This lock was offered by Simmons Hardware from 1914-192

 

Black & Decker 1/4" vintage hand drill. Drill works fine but there is a bad spot in the cord as seen in the pictures. The second drill is also 1/4" but the tag is pretty worn off. This drill also

 

Normal 0 false false false EN-US JA X-NONE Description Item: Vintage Crosscut Saw Helper Handle Condition: Near new condition; this handle may be new old stock; no scratches, marks, gouges or usage ma

 

Up for your consideration are these 2 Vintage Skeleton Keys- Hollow ends, ornate - 1 measures 2" long the other is 1 7/8" long with 3/4" tops. In very good used condition. Thanks for looking~ If any o

 

Interesting old brass key with 623 on the handle and a reverse 623 on the front prong. It is made in three pieces with the handle, shaft, and prong pair all made separately, but permanently attached.

 

YOU ARE BIDDING ON A VINTAGE UNION CHEST MACHINIST TOOL BOX. IT HAS THE UPPER SECTION AND 7 DRAWERS. IT WAS MADE BY UNION STEEL CHEST CORP. LEROY N.Y.. THIS HAS BEEN WELL USED BUT STILL IN GOOD CONDIT