Here is a Sharp Am/Fm table radio , this bright red radio looks great, it is not in working condition, when turned on , you get a low hissing sound, so it is being sold as is, for parts or repair, it

 

This is a really nice vintage alnico loudspeaker. Made by eminence the 33rd week in 1976 No issues It's 8 ohms. I will gladly answer any questions. US and paypal only. Thanks for viewing. Posted with

 

Klipsch Heresy HBR Speakers - Matched Pair - All Original Tweeters: Klipsch K-77 Both stamped 14 824-0137 - One also stamped 505, the other 506 (Solder Type) Midrange Drivers: Klipsch K-53-K Both stam

 

Everything in the picture. The guy who sold this to me played it and it sounds great. Includes the cleaning kit, take up reel, an echo thing. Some tapes. There is also a cover but it doesn't snap or f

 

Up for auction. A pair of beautifully restored AR-3a speakers with original ALNICO woofers. During the restoration, all original material was used from Vintage AR. Replaced the old scratchy potentiome

 

I'm putting on some lots of audio tubes that I have obtained and tested. Here are (3) Mullard made 6DJ8/ECC88's that I have tested on my Heathkit TT-1 mutual conductance calibrated tube tester. They h

 

Up for auction is a lot of 4 6SL7GT tubes. They have been tested on a newly calibrated B&K 707 for mutual conductance where 22% is minimum good. They test as follows RCA 42/45, RCA 55/50, RCA 40/4

 

Vintage Craftsman Solid State Radio AC/ Battery AM/ MB/ SW/ FM/ PSB Radio works, one antenna pulls out of radio, Model 1960-P Vintage Well Used condition. needs cleaned up.

 

This is a good clean Zenith Transoceanic radio chassis. It is as shown and it plays excellent. No issues. You will need the anteanna to make it work. It has been tested and comes with the original kno

 

Up for grabs is a great vintage Technics SA-5160 Receiver for Parts or Repair. It powers up fine, but the tuning needle only goes about halfway through the stations when the dial is turned. Sold As Is