GOOD+ BENCH JACK; QUALITY CENTERING TOOL WITH A COUPLE OF NO-HARM GRINDING MARKS,; STARRETT No 10 HOOKED RULE AND A No 270 WEDGE SHAPED RULE EACH HAVE SOME ROUGHNESS THAT MAY PARTLY POLISH OUT; BALL A

 

Medium grit natural oilstone, clean and flat, in pine box This is an unusual natural oilstone.Not one I'm familiar with, pale yellow in colour, medium/fine grit, sandstone type material.Non standard 8

 

Description: OLD VINTAGE SNAP ON RATCHET WRENCH. Model # GF749, Year: 1984, 3/8 drive, 7 1/2 inches long, The switch has scratches from transportation. Has some surface rust. No engravings. Good worki

 

Bernz No. 10 Blowtorch, Variety – This alcohol-fueled, blowpipe-type blowtorch was manufactured by the Otto Bernz Co. of Newark, New Jersey. The body of the torch is marked on two sides of the tank

 

This wrench is rusty and dirty. I can't quite read the embossed letter and numbers. It is 12 1/2" long. I have no clue what this is made for. Sold as is, no returns. Thanks and please check out my oth

 

8 1/4" TALL SOLID STEEL L S STARRETT I AM TOLD IT IS THE BASE FOR A DIAL INDICATOR

 

You Are Bidding on 1 original . These ceramic craft magnets are approx. 1/2" in diameter, and 3/16" thick. They are a C8 strength, which is the strongest ceramic magnet available. These magnets do not

 

Here is a HTF vintage Keen Kutter No 7C corrugated bottom Jointer plane offered by E. C. Simmons Co from 1906 thru 1912. The plane is 22" long with a 2 3/8" wide extra thick cutter with the wedge and

 

This is a Milwaukee Orbital Sander, Model No. 6012. 120 Volts, 5 amps, 500 watts. Heavy duty industrial quality. Weighs just under 7 lbs. Used it on one project many years ago, an not since. Works per

 

old axe head,no handle