This Stanley #118 low angle block plane is in very good used condition. This plane is a low profile model made of stamped steel rather than cast iron. Consequently it is not subject to cracks or break

 

1975 Roper Whitney Punch No. 5 JR. Rockford, Ill USA. Roper Whitney Punch set in metal box, with instructions, key and all parts. All punches included & sizes are: 3/32, 1/8, 5/32, 3/16, 7/32, 1/4

 

VINTAGE HAND WINDING GRINDER + WHEELS x 2 FOR SHARPENING TOOLS etc.......BOTH WORKING THE SPEEDE WILL WIND BACK AND FORWARDS THE ERMAN TURNS IN ONLY ONE DIRECTION COMBINED WEIGHT IS 8 kgs

 

GOOD SAW GROUP. MADE FOR JAS MACFARLANE (GLASGOW), DENT IN BLADE. DISSTON D15 STRAIGHTBACK, ROSEWOOD HANDLE, ETCH FAINTLY PARTLY READIBLE, STRAIGHT AND BREASTED. ATKINS PERFECTION HANDLE SAW, WIDE, HA

 

Snap-On TOOLS FLANK DRIVE PLUS METRIC COMBINATION WRENCH 20 21 & 22MM 12 POINTS NEW LOGO STYLE # SOEXM20 20MM , SOEXM21 21MM & SOEXM22 22MM. IN VERY GOOD COND NOT ENGRAVED OR GRINDER MARKS LIG

 

4 vintage Buck Brothers wood carving chisels in poor condition. The 2 smaller ones need sharpened and the 2 larger ones need new ends ground on them. The handles are good with some carved initials on

 

&amp

 

a new reproduction blade set for the stanley #41-#44 plane 9 cutters 1/8"-3/16"-1/4"-5/16"-3/8"-7/16"-1/2"-5/8" toung 1/4" Rc64-66

 

Good afternoon folks....Today i am going to list several blacksmith anvil hardys, picked by me out of an old blacksmiths sons workshop...Most are big and impressive, and will fit a 7/8th inch hardy ho

 

Up for your bids is this A M T brass edge trimming plane modeled after the STANLEY 95. This standout plane looks lightly used and very well made. It has a skewed cutter that is 1 1/8" wide without a v