THIS IS A VINTAGE ODD LOOKING HAMMER FOR PEEING METAL.GOOD FOR BLACKSMITING. THIS HAMMER IS MARKED DIXON-5. IT IS 7" LONG. ON THE ONE END ITS 1 1/2 TO 1 1/4 OVAL AND 1 1/4 TO 1 1/8 OVAL ON THE OTHER S

 

Nice vintage Stanley No. 78 Rabbet Plane in original box with all the pieces (complete) except the instruction sheet. I not sure if an instruction sheet was included or not. This is in very good to ex

 

Vintage Stanley B-535 Dasco Pro Brick Dasco 437 Delaware USA Cold Chisel Stone Dasco Pro 436 3-1/2" Brick Set USA Stanley 3-1/2"18-535 USA Dasco 437 4" Delaware 9-3/4" long Others

 

VINTAGE STANLEY BAILEY No.6 FORE PLANE WITH ONE STANLEY S.W. LOGO MARKED CUTTER IN GOOD CONDITION, GOOD FRONT KNOB, GOOD HANDLE, BODY METAL PART NO CRACK NO CHIP OR DAMAGE FOUND, ORIGINAL PAINT 95% RE

 

SNAP-ON / BLUE POINT WRENCHES LOT OF FIVE (5) Snap-On Combination: 3/4-6pt. (OSH24) slight offset/9-3/4" lgth.; 10mm-12pt. (OEXM100B) slight offset/6-3/4" lgth.; 11mm-12pt. (OEXM11) slight offset/5-1/

 

Up for auction is a selection of Bonney brand combination wrenches. There are several duplicates of some of the wrenches/sizes (sorry, the duplicates aren't pictured, see complete list below). This is

 

This tool has never been used. The auction includes the manual This is a Signature Series Tool It is dated 1992 I do not have the Certificate of Authenticity There are no boxes with any of these tools

 

Here is "The Original Club" steering wheel lock that has been rarely (and formerly) used by a relative on her recently sold car. Since I have my own steering wheel lock for my car, this one is availab

 

Rare NOS, unused, vintage, Max Sievert, Made in Sweden blowtorch for soldering. The 1 3/4 pints (1.0 liter) tank is made from brass and is in very good condition without dents, scratches, signs of dam

 

Up for auction is this vintage H. Disston handsaw. This has the eagle medallion and split nuts. There is a slight wave to the blade. This measures approximately 29" x 4 1/2" and has about 8 TPI. This