THIS SET OF SHEARS HAS NEVER BEEN USED, STILL HAS ORIGINAL BLADE CLIP ON BLADES; I HAVE NOT SEEN ONE BEFORE!!! AND I HAVE BEEN IN SHEARING SHEDS SINCE MID 50'S IN VICTORIA. THEY HAVE NEVER BEEN SHARPE

 

MysteriousGT store We have a Lot of 5 1950-1975 Snap On VS-Series Angle Head Open End Wrenches up for Grabs! Included in this Lot are the Following Wrenches: (1x Each) VS5224 (3/4") - VS5222 (11/16")

 

Here is a VINTAGE LEVEL that I believe is made of BAKELITE. It is 4 3/8" LONG and in GOOD CONDITION with some wear but no damage. It appears to be accurate and was made by the GARRARD COMPANY in ENGLA

 

Wade & Butcher really clean collectible hatchet. well marked nice clean condition see photos. measures approx 12 inches long at handle. head measures 4 3/4 long and approx 2 7/8 across sharp edge.

 

I HAVE UP FOR AUCTION A COLLECTION OF EIGHT LOCKS AND ONLY ONE LOCK HAS A KEY. MASTER LOCK WITH KEY-MADE IN USA. THE REST OF THE COLLECTION IS A YALE LOCK, INVADER LOCK, SAMSON LOCK, MAIL LOCK, 101 LO

 

This is for this plane as shown which is in great condition and the blade is in great condition with no chips. The base is approx. 25.8 cm L Please check pictures carefully as they make up part of the

 

This tool is in mint condition. It is initial and personal mark free. Does not have a case. Comes with master and wrench.This micrometer will be shipped with personal care. Maximum Measurement (Decima

 

THIS IS A NICE HUGE LOT OF USED PLUMBING TOOLS THEY ARE ALL IN GOOD WORKINK CONDITION IN THIS LOT ARE 2 RIDGID PIPE CUTTERS FIRST MODEL 151 IT CUTS 1/4 TO 1-5/8 OD PIPE THE SMALLER RIDGID CUTTER IS MO

 

Up for auction is this very rare open end wrench set and holder. You can do your own research, the holder is a very early Vlchek with patent applied for. I very gently with enough lube and a polishing

 

This is a rare long handle 1/2" ratchet.Vintage Craftsman 15" long with no markings at all.I believe this was bought and never used. Was oiled and tested before listed.