THIS IS A PAIR OF 10 INCH NOS CURVED TOOTH AUTO BODY FILES WITH TWO CHAMPERED HOLES CANT FIND NAME CAME WITH BOX OF VINTAGE FILES ALL MADE IN USA SOLD AS IS $ 4.99 S.H

 

Old shapleigh hardware cobblers hammer. Total weight is 14.6 ozs. Head is slightly loose. Please email for any additional photos or questions. Most items are sent next day. All international shipments

 

THANKS FOR LOOKING, UP FOR SALE IS THIS NICE VINTAGE MULTI FOLDING POCKET JACK KNIFE MADE BY IMPERIAL RHODE ISLAND AND MARKED PAT PENDING. THE BLADE IS ABOUT 2 1/2 INCHES LONG AND THE KNIFE SHOWS SOME

 

This auction is for a vintage Belzer ratchet. The tool is marked "BELZER WINKEL RATSCHE No. 2058" and "D.R.G.M. VANADIUM-EXTRA GERMANY." The ratchet is in very good used and shows little use by the or

 

THIS A PARK 3 DRAWER MACHINIST TOOL BOX20" ACROSS AND 10 1/2" TALL TOOL BOX IS IN GOOD CONDITION LATCHES ARE RUSTY BUT WORK FINE DRAWERS LOCK IN PLACE WITH TOP LID SHUT I DO NOT HAVE THE KEYHAS I INSE

 

Very Rare Clayton & Lambert No. 8 Blowtorch, unmarked!! – This self-acting blowtorch was manufactured by the Clayton & Lambert Mfg. Co. of Detroit, Michigan, and dates from July, 1900. To op

 

This is a Disston D-8 hand saw that is just over 28" in length and has 6 teeth per inch. The blade is rust free and has no bends or kinks. Tha handle has its original finish and the top horn part ofit

 

Found these drill bits in an old tool box. They have numbers on them which I assume are the sizes. Not sure what kind of drill they go to but hope someone can use them.

 

This auction is for one LOT OF 7 VINTAGE YALE NO. 645 LOCKS, USED. THEY ARE MARKED: MADE IN U.S.A. WITH A YALE LOGO AND NUMBER 645 ON THE FRONT AND THE YALE & TOWNE MFG. CO. MADE IN THE U.S.A. ON

 

A vintage adze head in decent condition.The head is 8-3/4" in length and 3-1/4"wide at the widest point the hole where the handle would go is approximately 1-1/4"X 1-1/4" it does have some pitting fro