This adz is in very good used condition.No damage or repairs.The head is 9 3/4 inches long,with a 5 inch cutting edge.( very sharp ).It has a 28 1/2 inch hardwood handle.The head is stamped B&M R.

 

ANTIQUE VINTAGE SLEDGE HAMMER HEAD - 8 SIDED AND TAPERED - THERE ARE MARKINGS THAT I CAN'T MAKE OUT AND THE NUMBER 8 ON THE HAMMAR - APPRO 8 LBS - 7 1/2" LONG - VERY GOOD CONDITION>BUYER PAYS 11.00

 

HERE IS AN OLD SAMSON STEEL EIGHT LEVER PADLOCK. IT IS 2 1/2" x 3 1/2" TALL. IT IS IN GOOD CONDITION. SORRY BUT THERE IS NO KEY. IF YOU HAVE ANY QUESTIONS PLEASE EMAIL ME. THANKS FOR LOOKING.

 

4 new hand forged blacksmith tongs. Tongs are forged from A-36 steel and made to fit 1/8", 1/4" and 3/8" flat or square stock respectively (flat jaw tongs) and the bolt tong is sized for 1/2" square o

 

Vintage Flashlight RAY-O-VAC Baby Bullet Chrome Finish Vintage Flashlight RAY-O-VAC Baby Bullet with Chrome Finish. Used condition and 5 ¼” tall. Please look at pictures for condition and contact m

 

Early antique saw vise weighing almost 6 pounds. About 9" length. Jaws 9 1/4" wide. VG condition except bench bolt is broken. Diameter of bolt is approx 7 centimeters. Could be replaced or repaired. A

 

This listing is for a Philadelphia Tool Co. carpenter's hatchet head. This is a older company that was later bought by Plumb. This head does not have any personal markings but does have scratches and

 

This Jennings wood chisel is in very nice condition. It is approx. 1/4" and approx. 10" in length. Has a nice wood handle. It is marked C.E.Jennings Made In USA on the blade.

 

RARE 5/16" Tapered Drift Punch Hammer... Here is a very hard to find size drift punch in very good condition, this hammer is work ready and listed with NO RESERVE.. The punch tip is clean and crisp wi

 

Machinists measuring tool. Mitutoyo height gage with original box. 6"Adjusts smoothly. In good usable condition. Please check my auctions for more old and interesting tools. From Cape Cod Shops,Barns