For yor consideration One wood and metal barn pulley. The diameter of the wheel is 5 inches. It is approximately 8 inches tall. There is a peice of wood missing from the wooden wheel. ( see picture #4

 

Lenk No. 205A Halide Detector / Blowtorch, New – This little halide or refrigerant gas leak detector was manufactured by the Lenk Manufacturing Company of Newton, Massachusetts. To use as a leak det

 

UP FOR BID IS A VINTAGE DURO CHROME 1530-4 U.S.A BALL PEEN HAMMER IN GREAT CONDITION THE HANDLE CAN USE A SMALL WEDGE YOU CAN PULL HANDLE OUT OF HEAD FEEL FREE TO ASK QUESTIONS THANKS FOR LOOKING HAPP

 

Atwood Lanslide. Bnip.

 

These blades are in good working condition . The blades are 6" with 1/2" hole in the center. Selling as pictured . Please see pictures. Selling as-is, as found due to age / enjoyment . Please bid acco

 

i000000 Vintage Small Oil Can Oiler USA Old Tool Click Images to Enlarge You are bidding on a nice example of a used vintage Small Oil Can Oiler with "Made in USA" to the base and patent marks Photos

 

Check out the pictures below, for some auctions there may be more than shown above. Marked on the back KEEN KUTTER and 9 for the 9 inch blade length. A little light surface rust to clean off and a sha

 

UP FOR YOUR CONSIDERATION, (1) GOODELL PRATT NO. 245 CHEST / SHOULDER BRACE 2-SPEED DRILL IN EXCELLENT CONDITION. THIS DRILL AS YOU CAN SEE IN THE PHOTOS SAYS; AMERICAN MANUFACTURE GOODELL PRATT CO.TO

 

Field Clamp/Vise Cast Iron Metal small very little rust working condition 7" tall x 6" wide

 

Vintage MALL DRILL wit Right Angle Drive AdaptionThis Drill Runs Good, I don’t know what the Right Angle Drive unit does for sure but I believe it adapts other accessaries to the head for limited ar