So we have some old tubes NOS Tube Tube Socket Vaccum Tube Not sure Which Of These Is The Best Description For These. I Can Not Test These Due I Do Not Have A Tube Tester, The Equipment Was Clean and

 

NOS (New Old Stock) Capstan shaft for 50 Hz 6/12 pol motor 3.75 / 7,5 ips (9,5 / 19cm/s) for Revox G36 Revox Part No. 1.736.128-02 This is the 50 Hz version capstan, only for use in countries with 50H

 

This is from a Dynaco Stereo 70 I owned in the early 70s. Worked perfect then and carefully stored since. Guaranteed. I'll refund your money instantly if there's a problem. Shipping is $5 Thanks

 

Teac X1000R,auto reverse,DBX,excellent condition ,just serviced with new belt,pinch roller & capstan were taken completely apart & cleaned & relubed with silicone grease,heads cleaned &

 

Up for grabs is a Sansui 9090DB in working condition. I did notice that the aux input seemed to play at a lower volume than it should. This receiver is out of an estate and in my opinion could probabl

 

THIS IS A VINTAGE MARANTZ ST-400 AM/FM STEREO TUNER USED FOR LITTLE HOURS AND ITS IN LIKE NEW WORKING CONDITION AND VERY CLEAN WITH FEW MINOR MARK ON COVER AND THE AM ANTENNA IS MISSING BUT IT WORKS W

 

Up for auction is a Pioneer CT-F1000 tape deck. This deck powers up, but when you go to play a tape it will not play. There is some scratches on the face plate shown in the pictures. This deck is sold

 

Selling a single Altec N1500A crossover. it looks in very good condition the control moves freely dont have original knob. I have no altec speaker to test it with. sold as isOn Jul-24-12 at 22:55:45 P

 

HP41 X Memory 82181A PAC for programmable calculator I offer a HP 82181A X Memory Pac. It is in a very good condition. Untested, but assumed to work. Is used for the HP 41C 41CV and 41 CX Shipping cos

 

SingleOxford Alnico Magnet 12-inch speaker old stock replacement for your vintage Fender or Gibson Amplifier Tweed requiring a medium power speaker with Alnico magnet. I Will be at the Guitar Show in