Here's a nice tote and large beaded knob from what I assume was an old Union No. 4 plane or larger plane. I believe the tote is mahogany. The brass nuts on the hardware were obviously polished at some

 

LOT OF 6 OLD TANG CHISELS 3 BEVEL EDGE AND 3 WIDER SWEEP GOUGES ALL 4 ARE JUST SHY OF 1/2" WIDE ALL DISPLAY SPOTS / AREAS OF RUST AS SHOWN IN PHOTOS ALL OFFERED AS IS Check out my other items!

 

We're selling this fine old boxwood caliper rule made by Lufkin. This is the model #171 , a 6 inch - 2 fold caliper rule. The rule has the inch scale [ 1-8'' and 1/16'' ] Marked on the rule is -- No.

 

Antique Henry Disston & Sons Cast Steel Dovetail Miter Back Saw - No Reserve. It measures 15 inches long with a 10 inch cutting edge ( 2 1/8 inch cut depth). It has 14 teeth per inch. The blade is

 

EXTRA HEAVY EARLY BRASS PLUMB BOB 2LB. 2 OZ. THIS IS AN EXTRA HEAVY EARLY BRASS PLUMB BOB WEIGHING IN AT 2LB. 2 OZ. AND APROX. 6" LONG FROM TIP TO TIP. IT HAS NICE PATINA AND ALSO SOME VERY LIGHT SURF

 

Vintage Millers Falls Tools Plane #900 in the original box. The plane is in used condition and the box is also showing some wear.

 

This auction is for an old vintage ring-nose blacksmith tool The tool is used, shows wear but is in good condition. 14-1/4" long. Nice old collectible tool. Comes as seen in pics. Thanks for looking a

 

Vintage Antique Eastman Kodak Avoirdupois Weight Scale Complete! PLEASE do not send payment until you get my invoice so I can make sure Insurance has been added to the shipping/handling if it is being

 

I have for auction these 8 vintage carving chisel. all were purchased from the same estate. (see picture # 2) from left to right the names are as follows; 1st, e v tool co, cleveland ohio, 2nd is henr

 

Two vintage planes. Stanley 248 weatherstrip plane with 5 blades. Not sure if it is all there. Other one is made in USA dual plane with one blade. Used Posted with eBay Mobile