Good + Condition. The thoughtful restorer could do a lot worse than this. Surface rust. Almost all parts except bulbous hand part that retains blade, and, the blade itself. All the parts except the kn

 

There is a Barron multi purpose wood planer, three small hammers, a 1-32 KK punch, a Stanley Yankee #4595 screwdriver, a cast iron level, no maker's mark, a 6 inch sliding T bevel, two sandcasting too

 

This wrench is rusty and dirty. I can't quite read the embossed letter and numbers. It is 12 1/2" long. I have no clue what this is made for. Sold as is, no returns. Thanks and please check out my oth

 

For Auction is a Hat makers ruler. Boxwood 5 inches long with a brass extending engraved slide to a further 5 inches. Brass ends, ruler is flat, no warping, brass slide straight. Few marks or stains.

 

This vintage tool box is in good condition. The leather is in very nice shape with only a few scuffs and knicks but it has alot of paint flecs on it. The handle on top is in nice shape as is the hardw

 

Up for auction without reserve is a Bailey plane iron in pristine un-used condition. The plane iron has been sitting on a shelf for nearly 150 years in an old building until I found it. The plane iron

 

AIRCRAFT LOCKING SAFETY WIRE TWISTING PLIERS - TOOL DEVELOPMENT CO. NORTH HOLLYWOOD CAUp for auction is a beautiful set of Vintage wire twisting pliers. They have no rust, only some slight pitting nea

 

Here is a vintage wood and brass Stanley caliper rule. It is # 36 1/2 and is warranted boxwood as etched on the rule. The wood is worn and smooth, and both the brass hinge and caliper are tight and in

 

Vintage Oil Can; all brass . A few minor dents but in great shape, still works. The can measures 7/8" dia by 4.5" in length. . It's ready to be used or cleaned and placed on the shelf of your collecti

 

VINTAGE MACHINIST BOX IS IN GOOD SHAPE OVER ALL. HAS THE METAL CORNER PROTECTIVE HARDWARE, NICE DOVETAILED SIDES, THE DRAWERS ARE SOLID, THE BOX ITSELF IS NOT ALL BANGED UP. THE LEATHER HANDLE IS IN P