Offered for your bidding consideration is a very nice general purpose smoothing plane made by Stanley, Model No. 3. This little guy is shop ready. The iron (cutter) has a clean sharp edge. Everything

 

Is in good condition,

 

Snap-On Wrenches, 7 total: 6 Combination OEX series sizes 17mm, 15mm, 11mm, 10mm, 9mm, 5/8" 1 Flare / open end RSX series 1/2" I was told these series were made from 1967 to 1987, please research if y

 

Stanley Bailey Jack Plane No.5This Plane is used and in good condition. It belonged to my uncle who did fine woodworking and carving. He was most active in the 1950's and 1960's. Normal 0 false false

 

YOU ARE BIDDING ON A VERY NICE VINTAGE LATE 1860S TO EARLY 1870S BOXWOOD AND BRASS 36 INCH FOLDING RULER . NO NAME OR MODEL NUMBER IS PRESENT ON THE RULER . DOES HAVE BRASS TRIM RUNNING COMPLETELY ARO

 

Two (2) Hargrave "Superclamp" Cincinnati Tool 6" No. 44 C-Clamp This pair of c clamps are in good working condition. They show some wear, surface rust and needs some oil.

 

You are bidding on a used Union #43 Plane. This plane is complete. Please use the zoom feature and review any and all of the photos. The photo/photos are provided so that you can examine the item/item

 

Three tool bits for a Stanley model 130-A spiral ratchet screwdriver, and other similar tools by Stanley, Millers Falls, etc. The important point to know if these will fit your tool is the shank diame

 

1899 Clark Bros & Co, Milldale Conn Billhead & Request for Quote & Blueprint --- approximately 8” X 6” billhead, 5” X 8” quote request letter from Holmes, Booth & Hayden / Bras

 

Stanley Tools Older round side Stanley tools Bedrock 605 1/2 wood plane tool. Comes with all proper parts. Cap has light minor corner chip, rear rosewood is not broken. I have a hunch it was repainted