HUGE Robert Sorby (3) pc Chisel Set. You get a 25mm; 38mm; and 50mm chisel. These are 20" long and weigh over 5lbs. It is in very nice condition. These have been well maintained. Check my other auctio

 

Welcome to another DINOBOB auction! International buyers will pay a higher shipping fee. I ship worldwide...... Ask questions if concerned. YOU ARE BIDDING ON A...Vtg PLUMB 32 Double Bit CRUISER Logge

 

This listing is for a set of Bernard parallel jaw pliers. The pliers are a older set but still very usable. The pliers have had some clean up done but still have scratches and blemishes as well as wea

 

Antique/Vintage Large Bulky Brass and Iron Segal Co Padlock with key. Size is approx. 4 1/2in. T x 2 5/8in. W x 1 7/8in. Deep. Condition: bronze or brass and iron have age and use marks and patina. Th

 

Early complex 18thC moulding plane. 18thC looking moulding plane, flat shoulder with moulding detail to edge.No makers name.Profile is a Cove & Astragal with cove, ( 1 3/8" x 7/8") Original blade

 

SMALL BENCH VICE FOR JEWELLERS OR SILVERSMITHS ETC MADE WITH HAND RIVETS MEASURES 9 CM LONG. THE JAWS ARE 27mm LONG & 8 mm DEEP THE VICE CLAMPS NICELY BUT THE BENCH ATTACHMENT SCREW IS WORN SO IT

 

Neat old tool. Rare old Utica Fencing tool. 1942 Model 101/4" pliers. Good used condition with good jaws. Good one to add to a collection or use. Items I sell are from local sales and just wiped off a

 

Quite nice for being VERY old. Shows its age some but I would say still very useable. By the one lever it says Pat'd 10- 12- 97. One the back lever it says STANLEY. The bottom is 6 1/4" x 1 7/8" x 2 1

 

Collection from a machinist tool box. Pin and center punches.Mostly unmarked.

 

Kind of a neat tool that was probably made by a pattern maker for his own use. The nickeled part is a heavy casting that acts as a carrier for the blade mechanism (which is a modified Stanley No. 100