Axe is in very good slightly used condition. No major damage. Newer hickory handle. Axe is 26" long. Head is 7 1/8" with 4" edge.

 

A STANLEY BRAND..ENGLAND.HAND DRILL,NO. 803.WOODEN HANDLES,VERY ORIGINAL,WORKING,34 CM.LONG.

 

Featured here is vintage used stanley no.9 1/4 block plane with brass push handle,remains fully intact showing heavy use,remains as a great collectible and does need sharpened,be sure to check out som

 

This is a lot of 5 vintage blacksmith hammers all in good working condition just need handles.All but one has wood in head. 12 lb sledge marked Senior Japan very old and hard old steel 8 lb sledge mar

 

REAL NICE UNUSUAL PLUMB HATCHET USED VERY LITTLE CROSS HATCHING ON FACE, LIGHTWEIGHT WITH HANDLE 1LB. 2OZ. HEAD MEAS.APPROX. 6 9/16" TALL,CUTTING EDGE 2 3/16" FACE 1 3/8" X 1 1/4' "SOME RUST SPOTS SCR

 

This is an old tool catalogue from 1897 put out by Montgomery & Co., New York City, New York. It is catalogue No. 21. The covers on this book are worn and soiled as seen in the photos but are not

 

babeann Store 3 GROUP 1 OLD / VINTAGE WRENCHES 1 IS FROM LAMBOND DESIGN CLEVELAND,O.U.S.A. IT IS 8 1/4 IN. LONG MIDDLE ONE HAS ON IT 11 AUTO ON THE OTHER SIDE IS 6 OR 9 IT IS 11 IN. LONG LAST ONE IS 1

 

These 17-Keys are a good assortment. Thanks for Looking.

 

Up for bids I have these great, steel antique skeleton or barrell keys from the mid to later 19th century. 2 and 1/8th to 2 and 3/8ths inches long. The keys are great and beautiful and have VERY EXOTI

 

This auction is for a rare vintage MERIT Blacksmith Anvil The anvil is used, shows some wear and scratches but is in great condition. Weights 8 Lbs - 11.5 oz. 8-7/8" L x 2-1/8" W x 4" T Comes as seen