The Stanley Bailey No. 28 Carpenter's Plane is approximately 19" long X 3" Wide X 7" Tall. The Stanley No. 80 Cast Iron Cabinet Scraper is approximately 11.5" long X 4" Wide X 2" Tall. As you can see

 

ONE WINNING BID IN THIS AUCTION BUYS TWO ITEMS 1. DOUBLE BIT SWAMPING PATTERN AXE 11 1/8" X 4 1/4", 4 lb. approx. with logo ( BA AXE HEAD MADE IN SWEDEN 3 1/2 ) Some letters not clear. G of GBA faintl

 

Shipping Policy: I combine shipping on all purchases. I am also not responsible if your item gets lost or stolen in the mail. You might want to consider shipping confirmation and/or insurance. I will

 

i000000 Vintage No:0 Brass & Steel 2 1/2 oz Plumb Bob by MONUMENT vgc Old Tool Click Images to Enlarge You are bidding on a nice example of a vintage Solid Brass & Steel 2.5oz, (72g), No:0 Siz

 

Stanley # 60 1/2 Low Angle Block Plane, USA Made This is a Stanley # 60 1/2 low angle block plane in good condition. It's just over 6 inches long, not counting the knob, and the cutter is 1 3/8 inches

 

Lot of 3 vintage alligator wrenches. Top is marked SAXON, THE K & B CO., NEW HAVEN, CT. and the length is 8 1/4". The middle one is not marked and the length is 5 5/8". The bottom one is marked PA

 

This is a very unusual, but very decorative silversmithing hammer! The hammer is in great condition! The handle is crack and chip free and there is only a slight wiggle at the head. It's unmarked too.

 

UP FOR BID IS THIS NICE LOOKING IMPERIAL NO. 175-F FLARING TOOL MADE BY THE IMPERIAL BRASS MFG. CO. OUT OF CHICAGO ILLINOIS. IT COMES IN ITS ORIGINAL BOX (ROUGH CONDITION) AND WORKS ON TUBING FROM 3/1

 

This machinist's level is early (pre-1907), rare, and struck with the "C.F. Richardson" "Athol, Mass" trademark. It retains ~70% or more of its original japanning and bears an uncanny resemblance to a

 

Vintage Stanley Yankee No.41Y Push Drill with 9 Bits Nice condition. Thanks for bidding.