Four vintage Hand carving Chisels . With handle, WARD W ... P stamped on blade . Measures approx 8" inches top of handle to the chisel tip . Three (3), chisels minus handles . . . One stamped B. ADDIS

 

This offer is a vintage Jeweler's or Silversmith's "Chasing Hammer". This hammer has a 1 1/4" dia. crowned face. The hammer is 10" long, and weighs about 6 oz. The top of the head is lightly stamped;

 

lianro Store Vintage 24" Stanley Level Stanley Rule & Level Co. Made of Wood & Brass Patent 6-12-91, 2-4-96 & 8-28-96

 

Marshall-Wells Double edge axe, Marked Zenith with star above it.Marshall-Wells, a couple in middle that I can not make out and 31 on back. Head has a couple scratches on back side and a few nicks aro

 

Thank you for taking a look at this auction. You are bidding on a Millers Falls Drill lot. The egg beater drill has patent date of 1896 and the brace drill is #1322. PLEASE take a look at ALL of the p

 

VINTAGE ARMSTRONG A-1731-A 3/4"-7/8" OPEN END WRENCH IN GOOD CONDITION U.S.A. DescriptionCondition: used; this wrench is in good condition. This wrench has some scratches, from normal usage, additiona

 

This is a neat vintage pocket ruler that folds out to 12” long and includes a slide out caliper. The number “88” is stamped under the caliper portion as well as on the caliper piece. Condition:

 

You are bidding on a vintage Craftsman 4 in one offset screwdriver. This was my father's tool and has been stored on his workbench in the basement. Measures about 5 1/2" and has a regular and Phillips

 

True Value 3 1/2" Anvil Bench Vise Jaws measure 3 1/2" and opens to around 4 1/2 inches It is used so it does have dirt and minor surface rust ~ Good Working Order ~ See photos, they are part of the d

 

MORTISE [or PLOUGH] PLANE, early 1900s. Wood screws to adjust the wood guide, brass knobs, steel blade 1/4" wide. Measures 11.5" long x 10.5" wide x 7" tall. The blade is clean and sharp. I used it to