For auction is a Mustad farriers creaser/ fuller. I never used this one much so it is in real nice shape .Just cleaned it up and handled it . This creaser is like new. The blade width is just under on

 

VARIOUS ANTIQUE TOOLS

 

MINT N.O.S. 1/2" Punch Hammer... Here is a very nice hammer that is New Old Stock and still in excellent condition... The punch end is mint, measures 1/2" sqaure at the tip and expands to 1" at the co

 

Up for auction is this hardy. This is a 3/4" x 4" rounding swage for an anvil. The inside rounding surface diameter = 3/4". This is a cast steel piece from ATMA Tool Co. Please see photos to rate cond

 

CLEANING OUT A OLD COUNTRY STORE WAS THIS HANDY HOIST MINI BLOCK & TACKLE. LOOKS TO NOT HAVE BEEN USED MUCH. MADE BY WESTERN CONTROL CORPERATION WICHITA KANSAS

 

This auction is for a vintage Craftsman wood plane with the original box and 20 page pamphlet The plane is 9 ½ inches in length. It is in very good barely used condition. There is no damage or repair

 

RIMCO ROBERT IVENS MACHINERY COMPANY 613 W. Bruce St.Milwaukee WI 53204414-272-6686 Welcome to Robert Ivens Machinery Company Our Mission: Productive and Satisfied Customers Up for AUCTION: SNAP ON SI

 

This has some wear to the piece with the stamp in very good conditionThere is some wear to the brass from the set screwFunctions nicely and not sure if this is all originalThank you for your purchase

 

This is a 14 In. Bell System-B Ratcheting Bit Brace This bit brace is in very good condition. It is 14 inches long with a 10 inch sweep. Has minor scratches from normal use. Has no rust or pitting. Al

 

Rare snap-on air tank!!! Still in working condition, with hanging chain. Have also found out it is a 1931 model.