A vintage wrench manufactured by the Erie Tool Works in Erie, Pennsylvania U.S.A. It has been refurbished myself personally. Originally it had a bit of rust on it and some hammer marks across the back

 

Vintage 1 ¼ oz. (35g.) silversmith’s / jewellers hammer in good condition. A fine light weight tool with a clean rust free head with a ½” (12mm) diameter head with a slight convex face and taper

 

In very good, little-used condition. Slight bruising to wedge only.

 

Snap-On Wrenches, 7 total: 6 Combination OEX series sizes 17mm, 15mm, 11mm, 10mm, 9mm, 5/8" 1 Flare / open end RSX series 1/2" I was told these series were made from 1967 to 1987, please research if y

 

Up for auction is this vintage Crescent Tool Company Jamestown, New York, Eclipse Trademark No. 13 adjustable nail puller. It is in good used condition and the markings on it are really neat! My dad s

 

you are bidding on a nice Billings 3/4" breaker bar. this measures 21-1/2" long, and weighs 3lbs. it is in good used condition with minor scratches,and wear marks. a good heavy duty breaker bar. if yo

 

Various Lots of Vintage skeleton keys. Got out of basement of older gents locksmith shop around the Boston Area. More lots to be listed. No international shipping. 1 Sargent skeleton key, Some marked

 

Available is a 6512 Tool Box set with tray, smaller tool box and a wrench counter display. See photos for condition. Perfect for an entry level collector.

 

I HAVE A VERY GOOD USED STECOGE WELL MADE 4" ADJUSTABLE WRENCH . IT DOES SHOW ITS AGE AND USE WITH SOME LIGHT RUST SPOTS. SELDOM SEEN BRAND THAT SHOULD CLEAN UP NICELY OR LEAVE LIKE IT IS. USA POSTAGE

 

RIMCO ROBERT IVENS MACHINERY COMPANY 613 W. Bruce St.Milwaukee WI 53204414-272-6686 Welcome to Robert Ivens Machinery Company Our Mission: Productive and Satisfied Customers Up for AUCTION: VINTAGE ST