THIS UNIT IS FULLY FUNCTIONAL IT IS ONE THAT HAS BEEN SITTING ON MY “TO BE REPAIRED SHELVES” FOR SO LONG THAT I COULDN’T REMEMBER WHERE I LEFT OFF WITH IT. THE SHORT STORY IS THAT THE PARTS I HA

 

bose 301 Series II 2 woofers 3 tweeters with 4 brackets. 2 of the tweeters have the center caps pushed in a little. speakers worked fine and sounded great. 4 square woofer speaker covers. 1 corner twe

 

This is in very good working condition. My husband put a battery in the radio, and the batteries inside the amplifier and it worked!!! This is all in very good condition but there is one chip to the b

 

Hello and thanks for looking at my auction. We have a very nice example of an Altec Lansing 604B with the N-1000-B crossover for your consideration. Tested and working and sounding great. This was pur

 

Pair of EL84/6BQ5 Mullard Pair with VM label. Made in Great Britain. Same date code rX1 B8D. Tested 85 & 80.5 on B&K 606 tester.

 

UP FOR AUCTION IS for ONE ETA PD11LVP CONDITIONED POWER DISTRIBUTION1 BULB ON THIS UNIT IS BAD , AND THIS UNIT CAN ONLY BE PLUGED INTO 20AMP OUTLETS PLEASE SEE PHOTOS This unit came from a Professiona

 

15 NOS 23.5K Ohms 1/2 Watt Non Inductive Wirewound Resistors! Made by Eastern Precision Resistor (EPR) - 1960s Vintage. Low Noise & Great Sonics! - The Best! These items are part of a large invent

 

Vintage General Electric Clock Radio Clock works , Im not sure about the radio It has tubes , it needs cleaned. Measures 11 1/2" wide x 5" deep x 6" high the plastic on the front of the clock has dama

 

PIONEER CS-51VINTAGE PIONEER 16 OHM BOOKSHELF SPEAKERSTHESE SPEAKERS PERFORMED VERY WELL WITH MY FISHER TUBE AMP FOR A NUMBER OF YEARS.VERY NICE WALNUT FINSH THERE ARE SOME VERY LIGHT SCRATCHES AND ON