Snap-On Tools lot #16 Diag. Cutting Pliers #87C. I have a large amount of Snap-On Tools listed this week and I will combine to Save you on Postage and I use Flat Rate Boxes also if I can to Save you o

 

AS SHOWN IN THE PHOTOS. NO RESERVE.

 

This vintage well pulley measures 9 1/2 inches across at the pulley and 10 1/2 inches across if you measure the top half-round cover portion. Please zoom in to see details. This would make a great add

 

dreamsfound Store This is a near mint vintage Pelouze R-47 scale complete with two pans and 6 brass weights - it also has the original box with instruction card. The weights are 1, 2, 5, 10, 20, and 5

 

Vintage Auto Body Repair Hammer in good used condition I don't see a makers stamp on it any where. Thanks Posted with eBay Mobile

 

PROTO MODEL1368 VINTAGE RUBBER MALLET HAMMER AUTO BODY TOOL Rubber mallet head is chewed up on the ends. The wood handle also has plenty of wear. Please look at the pictures closely as they will show

 

You are bidding on a vintage Craftsman 4 in one offset screwdriver. This was my father's tool and has been stored on his workbench in the basement. Measures about 5 1/2" and has a regular and Phillips

 

Stanley Number 5 Jack Plane (Type 18) Only made from 1946-47. Reasonably clean plane. Has the correct black hardwood handles. Handles have been refinished. Some micro-pitting, some loss of japanning m

 

11 steel chisels and punches. Some have names stamped on them These are used but have many many more years of. Use 3 3/8" shortest 12" longest Heavy duty old school type Great old set from Grandpa

 

The anvil itself weighs about 15 1/2 pounds ON MY BALANCE BEAM SCALE. , SOME EDGE MARKS BUT NOT BAD . The face is flat again some hit marks . This well made little anvil has both Hardy and Pritchel ho