VINTAGE TACK MASTER HAMMER This hammer belonged to my grandfather who owned it many years. I don't know it's age ? It is in fine working order as seen in the pictures. It has the hammer on one end and

 

NICE ANTIQUE PLUMB BOB 150 MADE IN GERMANY 5oz  The plumb bob measures 2 3/4” long and weighs about 5oz. _gsrx_vers_634 (GS 6.9.8 (634))

 

Here's a nice tote and large beaded knob from what I assume was an old Union No. 4 plane or larger plane. I believe the tote is mahogany. The brass nuts on the hardware were obviously polished at some

 

_1 plug plier Robo RCP-9 new You pay shipping $ 5.00 in 50 states. Others countries pay shipping $15.00. bid with your confidence, happy bidding and thank you for watching.

 

Carving Tools 10 various cuts and uses stone carving chisels. I think these are pneumatic use based on the end styles. I didnt see any maker marks. Fresh local estate find ready for your use or collec

 

You are checking out an antique Stanley No.7 Plane. Farm fresh picked today (4-27-13) It is approx. 21" in length... large and beautiful! There is one very small chip in the handle. I dont know much a

 

This Stanley #118 low angle block plane is in very good used condition. This plane is a low profile model made of stamped steel rather than cast iron. Consequently it is not subject to cracks or break

 

In excellent condition. SWTM on one set screw. Happy Bidding!!!!!!!!!!!!

 

Up for auction is a Vintage G. I. Mix & Co No.1 EX Wood Chisel 3/4" Wide with No Handle. It is 8 1/2" long and has some wear and some staining and light rust but is in good used condition. There i

 

Up for Auction with NO RESERVE A big lot of Ford and Fordson Wrenches. 15 open end Ford wrenches 1 Curved Ford Specialty Wrench 1 Ford Monkey Wrench with quick slide feature 4 Open end Fordson Wrenche