Greetings and welcome. You are bidding today on a vintage machinist level. Manufactured in New Orleans right here in the USA it was made by Hall Level and is marked No 50. I find no indicator as to wh

 

VINTAGE MIX LOT TOOLS TWO ADJ.WRENCH/OPENING END WRENCHNICE LOT OF TOOLS:1) BARCALD BUFFALO ADJ.WRENCHMADE IN THE U.S.A.2) BETR-GRIP J.R.DANIELSON CO INCJAMESTOWN N.Y. U.S.A.3) BILLINGS OPENING END WR

 

H. Gerstner & Sons Machinest or Journeymans Wooden(Oak) Tool Chest Box Marked on the inside: Built by 79876543 H. Gerstner & Sons Dayton Ohio V 482 (in pencil) See picture #9 16" X 20" and is

 

National Steam Specialty Company (of Chicago, IL) 100PSI Double Spring steam pressure gauge. Used condition. Glass is missing from face (can be purchased from most any glass company at little expense)

 

For sale a fine looking - early Henry Disston & Sons small dovetail saw - Cutting edge is 10 inches in length - Saw length overall is 15-1/4 inches - Questions welcomed.

 

Vintage 1960's Snap-on 1/2 " drive ratchet. Measures 10 1/2" in length. On Mar-30-13 at 12:38:16 PDT, seller added the following information: The Snap-on SL710 ratchet was produced between 1967-1975.

 

This is one lot of vintage or antique blacksmithing tools. There are five tools total. There is a 14 1/2 inch by 5 1/2 inch by 2 inch hammer. There is a 19 inch pair of tongs. There is a 23 inch set o

 

Vintage Stanley hand plane. No.100. Squirrel handle. The plane in in good shape except for some drops of green paint. Thanks for looking.

 

ANTIQUE FORGED STEEL (Blue Bird) LARGE 12 3/4" TIN SNIPS SCISSORS METAL CUTTINGHeavy duty tin snips - 12 and 3/4" forged steel - please view all pictures* Buyers responsible for shipping. If actual sh

 

budgie2cheap Store An old 10 tpi saw by Disston,Philadelphia.good teeth,quite sharp,would benefit from a final honing.all nuts present,some splashes of paint on handle,but solid with no breaks.straigh