THIS MACHINIST LEVEL IS USED BUT IN GOOD CONDITION.THIS LEVEL WAS MADE IN USA IN NEW BRITAIN CONN. THERE ARE A FEW SURFACE RUST SPOTS ON IT.IT NEEDS A GOOD CLEANING AND THERE IS NO NICKS ON IT.

 

Wood Auger Bits 11 wood auger style drill bits ranging from 1/4 to 1" some duplicates and not Most are lightly rusted but should clean up. There are 11 bits that are about 9 ½ inches long. No bad kin

 

This is a huge old cast iron hay spear with a pulley for a barn that is marked Nellis and H-28-M. It looks more like a weapon to me. It measures about 40 inches long and weighs about 15 pounds without

 

Nice Vintage Stanley Yankee Number 41Y Bell System Wood Working Push Drill with the Bits/Drills A Stanley Yankee push drill marked Bell System NO 41Y. This tool is approximately 9 ¾” long. This ite

 

I PURCHASED THIS FROM A WINTER PARK FL DOCTOR'S ESTATE AND HE ONLY COLLECTED THE BEST. I HAVE TWO OF THESE THAT ARE MATCHING, SO IF YOUR INTERESTED IN A MATCHING PAIR, BUY BOTH. MADE OF SOLID BRASS, W

 

 

This auction is for a vintage brass US mail registry padlock. On one side it says REG’D US MAIL, on the side it says M 10241. It is about 2 ½ inches by 1 ½ inches, there is no key. Buyer pays ship

 

MysteriousGT store We have a Lot of 5 1950-1975 Snap On VS-Series Angle Head Open End Wrenches up for Grabs! Included in this Lot are the Following Wrenches: (1x Each) VS5224 (3/4") - VS5222 (11/16")

 

AS SHOWN IN THE PHOTOS. NO RESERVE.

 

Up for auction this week is an excellent example of a John Weiss long jointer plane in the German style. It is approx. 24" long, with a 2 1/4" wide blade. Clearly stamped with the John Weiss mark in f