ihs316 store 1950's Roy Rogers Dale Evans and Buttermilk Wrist Watch

 

The third picture shows the problem with this T-Rex. I'm not sure if its scuffed up or a little glue residue. Anyway the rest looks good.

 

Old Driver or Chauffer from an old cast iron toy car. Missing some original paint and has some rust. It measures almost 3" tall and almost 1 1/2" deep. Feel free to Email, corrections or comments or Q

 

Vintage Big Bang 60mm Big Bang Cannon Cast Iron Carbide Cannon 9" inches Long 6 1/4" inch Barrel Two Heavy Duty Rubber Tires Spark component is present, may need to be updated. Very good Condition exc

 

This vintage fire engine wagon comes with two drivers, three ladders, and a bell which is attached to the underside of the wagon. It measures approximately 30 inches long, 9 inches high (from the bott

 

Vintage Toy from the 50's9" tall x 2.25" aroundGlass pieces make excellent colorful designs.

 

Up for auction is a TONKA T-6 bulldozer in fair to good condition. There is a number on the underside that is 810659. It has the paint peeling and maybe some other thing missing. The track is not torn

 

NICE VINTAGE TOYBUT NEED TO BE FIXNO KEY NO TESTEDHEIGHT = 4 3/4" (12 cm)WIDTH= 3 1/2"(9 cm)

 

These cast iron figurines were part of a model train setup during the late 1930’sand 1940’s with very small signs of wear. Both are in very good condition. The brown blacksmith is marked M, 41\4 a

 

a 4 inch hubley cycle and side car/..no cracks or breaks . / paint is orignal / it rolls nice and displays great / tires were dried up from being on a shelf for 25 years , so i replaced them /