tHIS I SOLD AND ORIGINAL.IT IS IN PERFECT WORKING ORDER AND IT IS COMPLETE.IT HAS HAS A COUPLE OF REPAIRS AS SEEN IN THE PHOTOS AND AND A CHIP PHOTO 7.I HAVE TAKEN A FEW PHOTOS TO SHOPW THE CONDITION.

 

Description Japanese Vintage Woodworking Carpentry Tools Plane Hira Kanna Ishitsuki 石月Blade ...6 cm　 2.36 inchLength...26 cm 10.23 inchwidth... 7.5cm 2.95 inch Height ...3.5 cm 1.37 inch weight.

 

This auction is an assorted lot of hatchets. From the left of the first photo. #1 Half broad ax hatchet with a pole hammer end. Unmarked. Handle has damage below head (looks like a chunk was taken off

 

DIXON NO. 1 SEMI-STEEL BENCH MANDREL SHEET METAL FORMING TOOLDixon Semi-Steel Bench Mandrel Sheet Metal Forming ToolNo. 13/4" x 3/4" Tapered FootOverall Height 10-1/2"Rounded Horn on End1-1/2" Diamete

 

YOU ARE LOOKING AT AN OLD SAW SET USED TO SET THE TEETH OF A HAND SAW WHEN YOU SHARPEN IT MADE BY DISSTON RUSTY BUT WORKS FINE THANKS FOR LOOKING

 

you are bidding on 22 new sliding door locks made by different manufactures but siliar to comp x NAC8042

 

Stanley G12-060 plane is 6-1/4 inches long 1-3/4 wide and made in England . About a 1/8 inch chip on bottom piece at blade slot, see picture with red tipped pen pointing to it. Bottom has several larg

 

Fantastic Old Steel (?) Oil Can from Montana Ranch--1890-1930 Great old tool that comes from my friend's mother's estate. My friend's grandfather was a rancher in Miles City, Montana from 1890-1930 an

 

This is a Stanley no. 71 1/2 router plane in good usable condition. I have not cleaned it up and there is a small amount of surface rust and dirt on it. The handles are both good with no cracking. It

 

Up for auction are these 2 old hand forged blacksmithing or farrier tongs. One is 18" long and the other is 17" long. They have been used a lot by the looks. They have odd shaped ends. Please see pict